P2595EN01
08 - 2007
TECHnICIAn MEnu
16
2.2.1.3 - SOLENOID SETTING
2.2.1.4 - DRIPPING TIME
2.2.2 - SET POWDER
2.2.2.1 - POWDER DOSES
2.2.2.2 - DOSER SETTINGS
2.2.3 - SET ACCESSORIES
2.2.3.1 - ENABLE CUP
2.2.1.3
s
olenoId
valve
settIngs
It is possible to set the water flow rate of the single solenoid valves
expressed in cc/s (the default value setting in cc/s is indicated in
the selection dose table) to calculate the amount of water to be
dispensed.
2.2.1.4
s
et
d
rIPPIng
t
Ime
The wait time (programmable from 0 to 2000 hundredths of a sec-
ond) to the emission of an “end of dispensing” warning sound can
be set for each selection in order to allow the tubes to drain.
2.2.2
s
ettIng
the
Powders
2.2.2.1
P
owder
doses
This function is used for setting, for each selection button, the in-
stant product powder doses that compose the drink.
These are expressed in gr. (grams).
The display will indicate the combination of water and powder being
set (water 1 - powder 1, etc.) and the powder dose value blinking.
In order to verify the correct correspondence refer to the “Selection
dose table”.
2.2.2.2
s
ettIng
the
doser
unIts
This function is used for setting the flow rate of the single doser
units, expressed in g/s, to calculate the amount of powder to be
dispensed, for correct conversion of product dose values.
2.2.3
settIng
the
accessorIes
2.2.3.1
enablIng
the
cuP
This function is used for enabling or disabling cup dispensing for
each selection button.
