NEC UNIVERGE UM8500, Integration Manual

Page: 135 / 352

NEC NEAX 2000
WITH
OAI
125
To set the Message Center Interface (MCI) configuration
Verify the following configurations and settings.
1
Verify that the
CP14 card is plugged in to MP12/FP12 slot.
2 Verify that t
he RS=0 to MCI (RS 0 is the lower socket on the CP14 card)
connection.
3 Verify that t
he 9800,8,n,1 serial communication parameter settings are set
as described in the table below. If a parameter is not the same, change it to the
setting in the table.
To set the OAI configuration
Verify the following configurations and settings.
1
Verify that the
CP14 card is plugged in to MP12/FP12 slot.
2
Verify that t
he IP Address is set per the phone system configuration,
Example 172.16.19.61.
3 Verify that t
he Subnet mask is set per the phone system configuration,
Example 255.255.255.0.
4
Add the non-default extensions lines (non-default hardware LENS): 224-239.
5
Verify that t
he OAI pilot is set per the phone system configuration, for
example 299.
6
Verify that t
he monitored extensions or voice ports are set per the phone
system configuration, for example 208-231.
7
Verify that t
he monitored DTerm Function Keys on extension 201 set per
the phone system configuration, for example 09-12 (function codes F1032-
F1035; Terminal Mode Facility codes 192-195).
8
Verify that t
he OAI monitoring slot 60030, in the OAI server configuration
according to the OAI XML template chosen, is set to:
Clear Data CCC
Backup/Save EC6>0> 3 = idle; 0 = start backup
IMPORTANT
Only adjust the MCI settings if the OAI UCD with Serial MCI
integration is being used.
Command Description
0401>01>0 Connection port for MCI = 0
08>708>0 MCI extension length = 6 (!)
08>025>0 Message indication = MESSAGE
08>443:1-0 Set the type of VMS integration: MCI (0) instead of
DTMF (1) (!)
4000>0>10 Function = MCI
4001>0>1 Data length = 8 bit
4002>0>1 Parity check = Ineffective
4004>0>0 Stop bit = 1
4008>0>4 Data speed = 9600 bps
Command Description
B-load, C-load Reset PBX memory
F83>0>… IVR # (need to save and restart system to take
effect)
Task Key(s)