Chapter 10 System Input/Output (I/O) Interfaces
Page 10-4
UNIVERGE
NEAX
2000 IPS
Request for Proposal (RFP) Reference Guide
Issue 6
Combinations for Center Office of Centralized Billing
SMDR
Former 2400 IMS Format
Extended 2400 IMS
Format
SMDR with AP00
(PN-AP00-B with MRC-C program)
X —
SMDR with AP00
(PN-AP00-B with MRC-F program
)
X X
MP built-in SMDR on RS-232C
— —
MP built-in SMDR on IP
X X
X: Available —: Not available
Note:
Only one output can be used at the center office.
Combinations for Local Office of Centralized Billing
SMDR
Former 2400 IMS Format
Extended 2400 IMS
Format
SMDR with AP00
(PN-AP00-B with MRC-C program)
X —
SMDR with AP00
(PN-AP00-B with MRC-F program
)
X —
MP built-in SMDR on RS-232C
X
X
MP built-in SMDR on IP
—
—
X: Available —: Not available
Note:
Only one output can be used at the local office.
Service Conditions
SMDR can be programmed to record all outgoing calls or toll calls only, depending on the
customers' requirements.
When customer provided computer equipment is connected using the RS-232C interface, SMDR
information will be transmitted directly to the equipment as each call record is completed.
If the outgoing call is directed to a trunk, which does not supply answer supervision, SMDR will start
recording the call approximately 10 seconds after the last digit has been dialed.
Supervision of the status of the external RS-232C terminal is not supplied.
There are two kinds of SMDR features as follows:
a. Built-in SMDR
The MP card has two RS-232C ports for SMDR. This card provides memory for a maximum of
1024 calls, and provides a record of a maximum of 255 trunk calls simultaneously for a
maximum of 6-digit extension number.
Note:
In case of built-in SMDR, if the station number is a 7- or 8- digit number, the upper one or
two digits are sent as Calling office Number and the last six digits are sent as Calling Number in
the call record format.
