2-4 Setup and Operation
NOTE:
If the system displays a message
indicating that system settings have changed, run
Setup (see System Configuration later in this
section).
Figure 2-4 Power Button, Lamps, and Suspend Button
5.
Press the suspend button (see Figure 2-4) to place the unit in the maximum power
saving mode.
A blinking power lamp indicates that the system is in the power-saving mode.
Pressing a key or moving the mouse places the system back in the Full-Power
mode.
If the system is left alone for a preset time (15 minutes), it goes into the automatic
Standby mode. The screen goes blank and the system goes into the power-saving
mode of operation. Moving the mouse or pressing a key places the system back in
the Full-Power mode.
CD-ROM READER
An NEC 8X CD-ROM reader (see Figure 2-5) comes preinstalled as drive E in the
multimedia configurations. The reader is set as a master device, and is connected to the
secondary IDE/PCI port on the system board.
NOTE:
The CD-ROM reader installed in the
system might look different than one shown in
the following figure. The locations of the other
features may vary but the functions are the same.
Power Button
Power Lam p
D isk Lam p
R eset Button
Suspend Button
