NEC N8100-1223F, User Manual

Page: 220 / 482

4-132 Configuring Your Server
The following figure illustrates the jumper switch location.
„
Pins for protecting/clearing the passwords
Short-circuit these two pins to clear the passwords.
Open these two pins to protect the passwords (factory-set).
„
Pins for protecting/clearing the CMOS data
Short-circuit these two pins to clear the CMOS data.
Open these two pins to protect the CMOS data (factory-set).
6.
Reassemble the server and press the POWER switch.
7.
When the POST screen appears, power off the server and unplug the power cord.
8.
Restore the jumper switch setting.
NOTE:
Place the clip over the jumper pins 11 and 12 after use to keep
the pin. Placing the clip over any other pins may cause malfunction of
the server.
9.
Reassemble the server and press the POWER switch.
10.
Run BIOS setup utility and restore the parameter settings recorded in Step 1.
If you have cleared the password, set it again as needed.
11.
Save and exit the utility.
Pins for protecting/clearing
the passwords.
Pins for protecting/clearing
the CMOS data. Jumper clip
Pins 11 and 12