NEC Express5800/140Rf-4, User Manual

Page: 313 / 461

Troubleshooting 8-49
The server is not found on the network:
8
Is the LAN cable connected?
→
Make sure to connect the LAN cable to the network port on the rear of the server.
Also make sure that the LAN cable to use conforms to the network interface
standard.
8
Is BIOS configuration correct?
→
The onboardLAN controller may be disabled with the BIOS SETUP utility of the
server. Check the setting with the BIOS SETUP utility.
<Menus to check:
[Advanced] - [PCI Configuration] - [Embedded NIC 1], [Embedded NIC 2]>
8
Have the protocol and service already configured?
→
Install the distinctive network driver for the server. Make sure that the protocol,
such as TCP/IP, and services are properly specified.
8
Is the transfer speed correct?
→
Open the network property dialog box in Control Panel to specify the "Link Speed
& Duplex" value the same as the value specified for HUB.
PCI hot-plug fails:
8
Is BIOS configuration correct?
→
You must change the BIOS configuration to use the PCI hot-plug feature.
<Menus to check: [Advanced] - [PCI Configuration] - [Hot Plug PCI Control] -
[Minimum/Middle/Maximum*]>
* Setting value depends on the board to be installed. See Chapter 4 for details.
The driver of a PCI board cannot be stopped from the OS when Hot Remove or Hot Replace is
executed for the PCI board:
8
Is another software using the PCI board for which Hot Remove or Hot Replace is to
be executed?
→
If another software is using the PCI board for which Hot Remove or Hot Replace
is to be executed, the driver of the PCI board cannot be stopped.
Terminate the software, then stop the driver of the PCI board. If executing Hot
Replace, restart the software after having mounted a new PCI board.