The Update Utility and SMDR
5-2
◆
Section 5: Maintenance Options and SMDR
DS1000 Hardware Manual
Testing the Connection
To test the connection:
1.
Open HyperTerminal on your Windows PC or laptop:
- Click
Start
+
Programs
+
Accessories
+
Communications
+
Hyperterminal
.
- Double-click
Hyperterm.exe
.
- Name your connection, pick an icon, and click
OK
.
2.
When you see the
Connect To
screen, open the
Connect using
drop down and select
Direct to Com n
(where n is the number of the PC COM port connected to the system).
3.
Click
OK
after making your selection above.
4.
When you see the
COMn Properties
, set the parameters to the following:
-
Bits per second
= 19200
-
Data bits
= 8
-
Parity
= none
-
Stop bits
= 1
-
Flow control
= none
5.
Click
OK
after making your selections above.
6.
Press
Enter
.
You should see some diagnostic data. If you press Enter again, you will see:>
If you don’ t see anything (or garbage) on your screen, check your connections and HyperTer-
minal settings and try again.
7.
From the PC or laptop keyboard, press Shift 1 to enable history.
To verify the connection, lift the handset or use features at any telephone. History data will dis-
play on the PC or laptop screen.
8.
Once you have veri
fi
ed that everything is working OK, press
Shift 1
again to disable history.
Checking the System’s Serial Port Settings
To check the system’s serial port settings:
1.
Enter the programming mode.
2.
Enter
0301
+
HOLD
.
3.
Press
VOL
▲
until you see:
BAUD?nnnn
4.
Enter the new baud rate, if re
HOLD
.
(0=1200, 1=2400, 2=4800, 3=9600, 4=19200, 5=38400)
5.
Press
CONF
to exit program 0301.
OR
Go to Programming SMDR below.
Note: You can press
Ctrl
+
Break
on the PC connected to the system serial port to toggle through the avail-
able system baud rates.
Programming SMDR
For additional SMDR programming options, see
Station Message Detail Recording
in the
Software Manual
on your
System Document CD
.
●
0301: SMDR Port
Enter 1 to enable SMDR output from the system’s RS-232-C port.
●
0301: Print SMDR Header
Enter Y to have the beginning of the SMDR report include the column header data. Enter N to have the
SMDR report only include the call data (without the header).
●
1001: Print SMDR
Enter Y to have the SMDR report include calls on the trunk. Enter N to have the SMDR report exclude
calls on the trunk.
Summary of Contents for DS1000
Page 6: ...Table of Contents iv Table of Contents DS1000 Hardware Manual...
Page 20: ...The Extension Block 2 4 Section 2 Trunk and Extension Cabling DS1000 Hardware Manual...
Page 42: ...Keyset Self Test 4 18 Section 4 Optional Equipment DS1000 Hardware Manual...
Page 58: ...Parts List 6 8 Section 6 Specifications and Parts DS1000 Hardware Manual...
