2-OPX Module
DS1000 Hardware Manual
Section 4: Optional Equipment
◆
4-11
4
Programming 2-OPX Modules
The 2-OPX Module is a two-channel device that represents two station ports. The
fi
rst channel is called the
primary station; the second channel is called the secondary station. The primary station auto-IDs when you
plug in the 2-OPX Module. It has the same station and extension number as a keyset would plugged into the
same port. You must set up the secondary
station in programming.
To set up the 2-OPX Module secondary station:
●
In
9902 - Set Up Stations (DS1000)
, assign an unused station number (e.g., 27) to the 2-OPX Module
secondary station. (If you use station 27, the secondary station’s extension number will be 326.) Refer
to
9902 - Set Up Stations (DS1000)
in the
Software Manual
on the
System Document CD
that came
with your system for more.
Note:
You must set up the 2-OPX Module secondary station before it will function.
Wall Mounting the 2-OPX Module
To wall mount a 2-OPX Module
(Figure 4-8)
:
1.
Following the diagram below, switch the screws that secure the 2-OPX Module cover from the outside
holes to the inside holes. Do not tighten the screws.
2.
Attach the wall mount brackets to each side of the 2-OPX Module and tighten the screws.
3.
With the connectors facing down, mount the 2-OPX Module to the wall using suitable customer-pro-
vided fasteners.
Use the 2-OPX Module as its own mounting template.
4.
Connect the 2-OPX module as described on the previous page.
Figure 4-8: Wall Mounting the 2-OPX Module
80000 - 57
Summary of Contents for DS1000
Page 6: ...Table of Contents iv Table of Contents DS1000 Hardware Manual...
Page 20: ...The Extension Block 2 4 Section 2 Trunk and Extension Cabling DS1000 Hardware Manual...
Page 42: ...Keyset Self Test 4 18 Section 4 Optional Equipment DS1000 Hardware Manual...
Page 58: ...Parts List 6 8 Section 6 Specifications and Parts DS1000 Hardware Manual...
