NEC DS1000, Operation Manual

Page: 28 / 62

Analog Door Box
4-4
◆
Section 4: Optional Equipment DS1000 Hardware Manual
Programming the Door Box
Door Box Setup
You must assign the chime pattern to each installed Door Box.
●
In 1801 - Door Chime , enter the Door Chime type.
0 = Normal Ring Group ringing.
1 = Low pitch chime pattern.
2 = Mid range pitch chime pattern.
3 = High pitch chime pattern.
If you enter Door Chime type 0 (normal ring) above, you can set up Call Coverage keys for the
Ring Group. This allows extensions that are not members of the Ring Group to answer Door Box
calls. Extensions with Call Coverage keys to the Door Box Ring Group can also activate the relay
(see Door Box Relay Control below).
Door Box Ringing
When a visitor at the door presses the Door Box call button, the Door Box will alert (chime) all the exten-
sions in the Ring Group to which the Door Box belongs. For example, if the Door Box and extensions 301
and 302 are in Ring Group 1, pressing the call button alerts 301 and 302.
● In 1802 - Ring Group Number , assign the Door Box and the extensions that should alert to the same
Ring Group (1-8).
●
Ring Groups 1-8 are preset to use master numbers 600-607.
Door Box Relay Control
You normally set up Door Box 1 to control the Door 1 relays, and Door Box 2 to control the Door 2 relays
(see
1801 - Relay Owner below).
●
In 0201 - Door 1 Relay , to assign the Door 1 Relay for door strike control, enter 1.
●
In 0201 - Door 2 Relay , to assign the Door 2 Relay for door strike control, enter 1.
●
In 1801 - Relay Owner , for the Door Box extension (324 or 325):
- Enter 1 to have the Door Box control Door 1 relays.
- Enter 2 to have the Door Box control Door 2 relays.
Figure 4-2: Connecting an Analog Door Box
BLK BLUE GRN
YEL
To DOOR1 in
DS1000 cabinet
WHT RED
80200 - 30
NC
NC
Door Box 1
Door Box 1
Relay
Door Box 1T
Door Box 1R
Relay 1T
Relay 1R