Neatech EVO3, Service Manual, Page: 83 / 93

www.neatech.it
83
5.5 Electronic Troubleshooting
Problems
Possible cause Action
The wheelchair doesn’t start
Batteries discharged Charge the batteries
Any Rnet cable not properly
inserted
Check all Rnet cables
The wheelchair cannot be
driven
Battery charger connected
Disconnect the battery
charger
Brake release lever not
correctly engaged Set properly the brake
release lever (UP)
The wheelchair can only be
driven at reduced speed
The position of the seating
system is such that some
inhibition occurs Set the wheelchair in the
DEFAULT POSITION, see
section 2.7.2
The wheelchair cannot be
charged Main circuit breaker
switched off
Turn off the main circuit
breaker. If the problem
persists see section 5.6
5.6 Rnet system fault
When the control system is triggered and the wheelchair can’t be used, a diagnostic screen is
displayed in the display of the joystick.
First switch off the wheelchair and leave it off for some minutes. Then reboot the wheelchair. If
the fault still continues, contact an authorized service center.
Figure 92
Seeing Figure 35:

Identified Module indicates the module that had the problem
For example:
PM
Power Module
JSM Joystick
ISM Light Module
CxSM Seating Module

The Trip Text is a brief description of the problem

The Trip Code is a four digit code that allow an authorized service center to identify the
problem