Neatech EVO3, Service Manual, Page: 31 / 93

www.neatech.it
31
Remove and assure inside the vehicle any accessory from the wheelchair in order to reduce the
potential risk of injury.
If the wheelchair has been involved in some type of collision between vehicles, it must be tested
by the manufacturer before re-use.
Don’t make any alteration or tampering on point of safety or structural parts.
Use extreme care when positioning the wheelchair, so that the release button of the seat belt
can not be pressed by its components in case of impact.
The hooks that can be used with the wheelchair are “Four-Point Tie-Down” type. The wheelchair
will be hooked up inside the motor vehicle in 4 points: 2 front and 2 rear, as shown in Figure 32.
Figure 32
Don’t use any postural support in a motor vehicle unless they are conform to
ISO 7176-19.