Neatech EVO3, Service Manual, Page: 18 / 93

www.neatech.it
18
2.6.3 Backrest
To perform the adjustment of the backrest for different type of height, you have to screw off
the nuts positioned over the four different bolts as it is possible to see in Figure 15.
To screw off the nuts, it is necessary an 8 mm open-end wrench.
Figure 15
After screwed off the nuts it is possible to adjust the height. To facilitate the mounting of the
backrest up the support it may be useful to remove the upholstery of the backrest.
2.6.4 Seat depth
To adjust the seat depth, loosen the 6 bolts on the right side and the 3 bolts on the left side of
the seat, as it is shown in Figure 16.
Figure 16
In this way one can move forward and backward the seat. When the chosen position is reached
it is necessary to screw again the bolts.
Figure 17