NCR 7452, User Manual

Page: 246 / 261

6-20 Chapter 6: BIOS Updating Procedures
You should see a message during boot indicating that the CD-ROM
has been recognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
6. Follow the screen prompts on the client to update the BIOS. You
can select two methods to run the update program.
•
Automatic BIOS Update – update process runs unattended
Note: You will see a prompt for terminal model and serial number
information if the program detects invalid information in the
current BIOS, or if you are replacing the processor board, in which
case there is not model/serial number information in the BIOS.
Important: Model/Serial Number is mandatory for FitClient
operation.
•
Interactive BIOS Update – permits you to input/replace the
model/serial number information that is stored in the BIOS.
Note: Model/Serial number data that is currently stored in the
BIOS is displayed during power up.
7. When you get the green window, this indicates a successful update.
8. Remove the CD.
9. Press any key to reboot.
10. Enter Setup when the terminal reboots and load the Setup Defaults
(Exit Menu).
11. From the Advanced menu, select Reset Configuration Data and
then use the space bar to change the selection to Yes.
12. Exit Setup and Save Changes.
Note:
After rebooting, enter Setup to make any custom changes.