Chapter 5: Operating System Recovery
5-5
Completing the OS Installation (Win98)
The system automatically reboots when the image recovery is complete
and starts the software installation. This installation also installs most
of the additional software and drivers that are included in the disk
image. Complete the installation as follows.
1.
When the terminal boots it enters the Windows setup routine.
Note:
When installing Win98 on terminals with early processor
boards (7452-30xx/35xx) there are few differences in the procedure
as follows:
a)
The terminal starts the Add New Hardware Wizard.
b)
For each device found, permit Windows to search for new
drivers (take defaults).
c)
After each driver is installed you are asked to reboot. Answer
No
.
2.
At the User Information screen, enter the User information. This
can be done using a keyboard or you can use the touch screen
keyboard. After entering the information, press
Enter
or touch
OK
.
3.
Go into the Control Panel and set the terminal Date and Time.
4.
In the Control Panel, run the MicroTouch screen calibration.
Summary of Contents for 7452
