3-28
Chapter 3: Installing Optional Hardware Features
To install the PCI LCD Board in the 7452 Workstation, follow these
steps:
1.
Power the system OFF.
2.
Remove the PCI LCD Board from static shield bag. Verify that the
W1 jumper switch is set to position 2-3 or that no shunt is installed.
16773
Keyboard Header Connector
(for optional internal harness)
Power Harness Connector
VGA BIOS
PS/2 Keyboard Connector
(Keyboard Adapter Cable)
LCD Connector
System Speaker
Connection
W1 Jumper Switch
and Shunt
3.
Using the manufacturer’s instruction manual, install the PCI LCD
Board into a PCI slot.
4.
Connect a female end of the PCI LCD Y-Power Harness to the PCI
LCD Board. Connect the male end to an unused power connector
from the system’s power supply harness.
Note:
If a power connector is not available, disconnect a component’s
power cable (such as a hard drive) and plug it into the PCI LCD
Y-Power Harness. (The Y-Power Harness has the extra female
connector for this situation.)
Summary of Contents for 7452
