Getting Started with MAXserver Access Servers
0038
86
configuration. If there are still no service offers, the unit will wait and then
try again, beginning with the primary configuration. Only the primary
default initialization configuration is enabled at the factory.
To display the settings for an initialization record, complete the following
steps:
1.
Type 1, 2, or 3 at the Display Unit Configuration Menu. The menu
displays a list of currently stored configuration values and the new
configuration values for the specified initialization configuration as
shown in Figure 30.
Stored Configuration New Configuration
Status: Enabled Enabled
Image load method: CARD XMOP MOP BOOTP RARP CARD XMOP MOP BOOTP
RARP
Parameter load method: NVS XMOP MOP BOOTP RARP NVS XMOP MOP BOOTP
RARP
Dump method: XMOP MOP BOOTP RARP XMOP MOP BOOTP RARP
CARD/XMOP/MOP filename: XPCSRV20 XPCSRV20
Default unit IP addr: 0.0.0.0 0.0.0.0
DTFTP host IP addr: N/A N/A
DTFTP gateway IP addr: N/A N/A
DTFTP filename: N/A N/A
(Type any key to continue)
Figure 30 - Sample Unit Configuration Display
Figure 30 shows how this display might appear for an enabled initialization
configuration (the values shown here are those of the factory default
initialization configuration).
2.
Press any key to return to the Display Unit Configuration Menu.