Getting Started with MAXserver Access Servers
0038
100
1.
Enter the access server’s IP address, or press RETURN to accept the
default address, 0.0.0.0. You must supply a non-zero IP address if you
have specified all image loading protocols or DTFTP as an image loading
method.
2.
Enter the load host’s IP address, or press RETURN to accept the default
address, 0.0.0.0. You must supply a non-zero IP address if you have
specified all image loading protocols or DTFTP as an image loading
method.
ENTER HOST IP ADDRESS [0.0.0.0]:
3.
If the load host is not on the same network as the unit, enter the
Internet address of a gateway.
ENTER GATEWAY IP ADDRESS [0.0.0.0]:
4.
Enter the name of the file to load (max. 64 characters).
ENTER TFTP LOAD FILENAME []:
5.
After you have specified a filename and pressed the RETURN key, the
menu prompts:
(TYPE ANY KEY TO CONTINUE)
6.
Press any key to return to the Modify Unit Configuration Menu
Miscellaneous Unit Configuration
The Modify Unit Configuration Menu, is where you can change the following
unit settings:
·
Enable/Disable Status Message display.
·
Configure the amount of memory installed in the unit.