169
23. Using a 6mm hex wrench, finish removing the Adjustment Bolt from the Rear
Roller.
Note:
Be sure to record the number of turns of the Adjustment Bolt it takes to
remove it. This will assist with reassembly.
24. Slide the Rear Roller out of the Walking Belt.
25. Slide the old Walking Belt off of the Deck, and replace with a new Walking Belt.
26. Slide the Rear Roller into the new Walking Belt in the same orientation.
27. Using a 6mm hex wrench, re-attach the Adjustment Bolts to the Rear Roller.
Note:
Be sure to tighten the Adjustment Bolt the same number of turns it took to
loosen the Walking Belt.
28. Using a 6mm hex wrench, re-install the 3 screws to the Deck.
29. Slide the Front Roller into the new Walking Belt in the same orientation.
30. Loop the Drive Belt around the Front Roller. Insert the end of the Front Roller
with the Drive Pulley into the Frame and pivot the other end into the Bracket.
31. Using a 6mm hex wrench, attach the Front Roller to the Bracket.
Note:
Tighten the hardware until the Front Roller is centered in the Bracket.
32. Loop the new Drive Belt around the Motor Pulley. Start the Drive Belt on the
Drive Pulley and roll it in a clockwise motion. Be sure the Belt does not come off of
the Motor Pulley.
Keep fingers out of any pinch opportunities when turning the Pulleys.
33. Roll the Drive Pulley clockwise until the Drive Belt is fully installed. Continue to
roll the Belt forward while adding side pressure with fingers to align as necessary.
34. Inspect the Speed Sensor to see if it has been moved during the procedure. If
necessary, adjust it to be the observed distance from the Drive Pulley.
Rear Roller
=
Drive Pulley
Motor Pulley
Speed Sensor
