125
8. Attach the power cord and turn on the Treadmill by flipping the power switch to ON.
9. From the Power Up (or Welcome) screen, push and hold down the PAUSE/STOP button and Right arrow button for about 5 seconds to go into the
Console Setup Mode. The Console display will show the Date prompt with the current setting.
10. Push the OK button 4 times until the Console displays the TOTAL RUN HOURS screen.
11. Push and hold down the PAUSE/STOP button and Right arrow button for about 5 seconds to go into the Engineering Mode. The Console display
will show the current Firmware Version.
12. Push the Down arrow button 4 times until the Console displays “RUN MCB CAL”.
Be sure the area around the Treadmill is clear of all bystanders, children and pets. Be sure there is nothing on or under the Walking
Belt, or near the Treadmill.
13. With the area clear, push the OK button. The calibration procedure will begin by automatically moving the Walking Belt and lifting the Deck
through the full range of incline motion.
Be sure not to touch or allow anyone else to touch the machine while calibration is occurring.
14. When calibration is complete, the Console will display “done” for a few seconds, and then return to the “RUN MCB CAL” option.
15. Flip the power switch to OFF. Calibration is now complete for the machine.
16. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner’s
Manual.
5. Using a #2 Phillips screwdriver, remove the 2 indicated screws that
attach the Motor Control Board (MCB) to the Frame.
6. Remove old Motor Control Board, and install the new Motor Control
Board. Connect all the cables to the MCB in their proper locations. Be
sure not to crimp any cables.
7. Re-install all remaining parts that were removed in reverse order.
