121
26. Push and hold down the PAUSE/STOP button and Right arrow button for about 5 seconds to go into the Engineer-
ing Mode. The Console display will show the current Firmware Version.
27. Push the Down arrow button 4 times until the Console displays “RUN MCB CAL”.
Be sure the area around the Treadmill is clear of all bystanders, children and pets. Be sure there is
nothing on or under the Walking Belt, or near the Treadmill.
28. With the area clear, push the OK button. The calibration procedure will begin by automatically moving the Walking
Belt and lifting the Deck through the full range of incline motion.
Be sure not to touch or allow anyone else to touch the machine while calibration is occurring.
29. When calibration is complete, the Console will display “done” for a few seconds, and then return to the “RUN MCB
CAL” option.
30. Flip the power switch to OFF. Calibration is now complete for the machine.
31. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in
accordance with the Owner’s Manual.
