NARDA PMM CA0010, User Manual, Page: 63 / 74

Analyzer Mode Operating Instructions 5-5
When clicked, the Custom soft button enables a set of parameters that can
be edited as desired, within the limits of the main specifications.
Fig. 5-3 Custom signals parameters
In the Data Test frame, for the custom disturbance generation, it is possible
to set the duration of up to 4 events, each one with its amplitude, and a
different separation interval between them.
The Repetition box ca be used to set a time interval to program an automatic
N times redo of the events sequence.
Set the duration to 0 ms for each unwanted event.
In the example above, the disturbance generated will be as following
described:
- the carrier frequency will be 500 kHz (Frequency tab),
- external correction factor (for cables, attenuators etc) will be zero,
- wideband CISPR pulses are switched OFF,
- at first the carrier will be ON for 30 ms, with an amplitude of
66.3 dBµV (E1),
- then will be OFF for 180 ms (Separation),
- again ON for 30 ms, with an amplitude of 66.3 dBµV (E2),
- then will be OFF for 100 ms (Separation),
- again ON for 30 ms, with an amplitude of 46.3 dBµV (E3),
- OFF for 100 ms (Separation),
- ON for 30 ms, with an amplitude of 46.3 dBµV (E4),
- The sequence above will be repeated every 3 seconds, for 10 times
(Repetition)