NARDA PMM CA0010, User Manual, Page: 52 / 74

4-6 Sweep Mode Operating Instructions
4.3 Highlight –
Open Ful
l An archived measurement can be loaded in Highlight mode or in Full
mode.
Highlight mode is a powerful and quick way to trace and put in evidence the
relevant events occurred during the acquisition of the disturbances.
Click the Open Full software button to load the entire measurement; it takes
a longer time than the highlight one, and it shows the complete trace of the
signal along the total time duration.
Higlight function may not show all the detected clicks. In case of dubts,
please reload the measurement in Open Full mode. The final report
shows always the correct count.
4.3.1 Data The Data frame collects the count of the occurred clicks, the elapsed time,
the rate (total clicks per minute). The lowest two boxes show the current
readings for IF and Quasi Peak detectors, in dBµV.
4.3.2 Details The Details frame contains the characteristics of the latest event detected.
The parameters are described below:
•
Last T : the duration in milliseconds of the latest click disturbance
• D<= 10 ms : current count of clicks which duration is less than 10 ms
•
10 ms < D<= 20 ms : current count of clicks which duration is between 10
and 20 ms
• 20 ms < D<= 200 ms : current count of clicks which duration is between
20 and 200 ms
•
E2 (d>200ms) : current count of Exception 2 occurrences
•
Other T.C. (ms) : total duration in milliseconds of Other Than Clicks
•
E4 : current count of Exception 4 occurrences
•
QP Delta (dB) : difference in dB between the measured max Quasi Peak
level and the set limit level
• Obs. Time : set time duration for current Run
•
Ref. : the level of the reference limit in dBµV.