NARDA PMM CA0010, User Manual, Page: 54 / 74

4-8 Sweep Mode Operating Instructions
4.4.1 Setup
When the software button is clicked, the Click Setup window pops up.
Here it is possible to:
•
set the value in dB of a possible external attenuator,
• choose the standard limit,
• set if rate calculation will be based on RF signal measurement
(Clicks) or on switching operations (current consumption threshold),
• set the f factor, when needed, as given in specific CISPR 14 Annex,
•
choose if terminate current step or go on anyway, when the test has
failed,
•
choose if terminate current run manually during acquisition, or
alternatively when 40 clicks are reached. In any case the step
terminates when the expected observation time is elapsed,
• in the Line frame it is possible to select the desired line of a PMM
LISN, if used in the test setup. PMM LISNs can be automatically
controlled by the 9010F receiver via the User Port connection,
•
set the maximum observation time,
• set Idle threshold level in dBµV. This is the threshold level, for clicks
detection, when a standard limit is not selected,
• choose if Single Run smart function will be adopted or not,
•
choose if use Exception 4, as provided by the standard,
•
select if rate calculation is based on the current (when this manual
was edited for the first time) standard edition (2 channels, 2
quartiles), or taking into account 2 channels, and then 4 quartiles, or
even considering a possible future regulation with 4 channels and 4
quartiles,
•
Set Click Setup soft button sends the settings to the analyzer when
clicked,
•
Default button retrieves a base standard set of parameters.
• digit the Name of the measurement to be executed and,
consequently, archived,
• Start soft button runs the acquisition after being clicked,
•
Idle soft button is used to enter the Idle mode, for EUT initial
evaluation, debug and testing purposes,
•
Exit soft button to close the Start window without running a new
measurement.