MUTOH Rockhopper 38, Maintenance Manual

Page: 12 / 258

Rockhopper 38 – Maintenance Manual
12
AP-74038, Rev. 1.1, 25/01/05
Do not connect earth cables in the following areas.
•
Gas pipes
→
Doing so may cause fire or an explosion.
•
Earth terminals for telephone line or lightening rod
→
Doing so may cause a large flow of voltage if
lightening occurs.
•
Water pipes or faucets
→
If there is a plastic part in the pipe, the earth will not work properly.
Do not insert or drop metal or inflammable objects into openings, such as ventilation outlets. Doing so
may result in electrical shock and fire.
Stop using your printer if a liquid is spilled into it. This may cause electrical shock or fire. Turn the
printer off as soon as possible, unplug the power cord, contact your local MUTOH dealer.
Be sure to use the attached cable. Otherwise, electrical shock or fire may occur.
Be sure to use the specified voltage (AC 100 V to 120V, or AC 220V to 240V). Otherwise, electrical
shock or fire may occur.
Use electricity directly from a power outlet (AC 100 V to 120V, or AC 220V to 240V). Do not put many
loads on one electrical output. Otherwise, heat may be generated and cause fire.
Be sure to use an outlet with an earth terminal and use the terminal correctly. Otherwise, electrical
shock or fire may occur.
Follow the instructions below when handling the power cable.
o
Do not modify the cable.
o
Do not put heavy objects on the cable.
o
Do not bend, twist or pull the cable.
o
Do not wire the cable near equipment that generates heat.
Follow the instructions below when handling the power plug. Otherwise, fire may occur.
o
Wipe away dust and any other residue before inserting the plug.
o
Ensure that the plug is firmly inserted as far as it will go.
When handling ink cassettes, be careful that ink does not get in your eyes or on your skin. However, if
this happens, flush immediately with water. Otherwise, your eyes may become congested or inflamed
slightly. If you feel discomfort, consult a doctor immediately.
Do not disassemble ink cassettes. Otherwise, ink may get in your eyes or on your skin.
Be careful not to pinch your fingers when opening and closing the front cover.
Follow the instructions below when connecting the network interface cable. Otherwise, electrical shock
or fire may occur.
o
Do not touch the connector.
o
Do not connect the network cable connector that is not the same specification to the interface board.
When cutting the roll media, be careful of the following. Incorrect handling can result in injury to the
hands and fingers from the razor blade.
o
When holding the media, do not place fingers over the media cut groove.
o
Move the razor blade slowly along the media cutting groove.
Do not use thinner, benzene, alcohol or other active agents. Doing so may result in damage or paint
peeling from the casing.
Be careful not to spill water inside the printer. Doing so may result in a short circuit.
Be careful not to touch the heaters during or after operation. Doing so may result in burns.
Only use Eco-Solvent Plus ink and appropriate Eco-Solvent Plus cleaning liquid. Using other ink (e.g.
dye or pigment) will cause permanent damage to the printer.
Never open the covers fixed with screws. Doing so may result in electrical shock or a malfunctioning in
the printer.
Do not touch the cutter blade. Doing so may result in bodily injury.