MUTOH Rockhopper 38, Maintenance Manual, Page: 102 / 258

Rockhopper 38 – Maintenance Manual
102
AP-74038, Rev. 1.1, 25/01/05
4.8.7 Replacing the Cursor Assembly
Step 1 :
Remove the Front Cover. Refer to “Removing Front Cover”
Step 2 :
Remove the Unit Panel Cover. Refer to “Removing Unit Panel Cover”
Step 3 :
Remove the Y Rail Cover. Refer to “Removing Y Rail Cover”
Step 4 :
Remove the Right and Left Covers. Refer to “Removing Right and Left Covers”
Step 5 :
Loosen the tension of the Steel Belt. Refer to “Replacing Steel Belt”
Step 6 :
Disconnect connectors J204, J206, J207 and J208 from the Head Board Assembly.
Step 7 :
Remove the Y cable. Refer to “Replacing Y Cable”
Step 8 :
Remove the ink tubes. Refer to “Replacing Ink Tubes”
Step 9 :
Remove the Head Cover. Refer to “Removing Head Cover”
Step 10 :
Remove the two Steel Belt fastening screws from the Cursor Unit. Refer to “Replacing Steel Belt”
Step 11 :
Remove the setscrew and remove each damper tube. Refer to “Replacing damper”
Step 12 :
Remove the Cursor Plate Spring
Step 13 :
Lift up the Head Board Mounting Plate and take it from the Cursor
Caution:
Be careful not to damage the Timing Fence and Sensor which are underneath the
Head Board
Caution:
Be careful not to touch or damage the Head Nozzles
Step 14 :
To install removed components, reverse removal procedure.