MUTOH Rockhopper 38, Maintenance Manual

Page: 162 / 258

Rockhopper 38 – Maintenance Manual
162
AP-74038, Rev. 1.1, 25/01/05
7.2.5 Capturing and installing Backup Parameters
Caution:
Failure to switch off the power before mounting and unmounting flash memory card
may cause damage to the Main Board and make it impossible to install data
properly.
7.2.5.1 Capture backup parameters
Step 1 :
Switch off power to the printer.
Step 2 :
Mount a backup-only flash memory card in the slot at the back of the printer.
Step 3 :
Turn on the power. All LEDs light up instantly and “PLOTTER”
→
CARD” appears in the printer’s
LCD display unit.
Step 4 :
When “ENTER” is pressed, “P
→
C Started” appears in the printer’s LCD display unit and
parameters start to be absorbed.
Step 5 :
When parameters have been completely absorbed, “P
→
C Completed” appears in the printer’s
LCD display unit to indicate that the comparison of absorbed parameters has ended normally.
Step 6 :
Switch off and remove the flash memory.
7.2.5.2 Install
Step 1 :
Switch off power to the printer.
Step 2 :
Mount a backup-only flash memory card in the slot at the back of the printer.
Step 3 :
Turn on the power. All LEDs light up instantly and “PLOTTER”
→
CARD” appears in the printer’s
LCD display unit. “Menu Up” or “Menu Down” will change this to “CARD
→
PLOTTER”.
Step 4 :
When “ENTER” is pressed, “C
→
P Started” appears in the printer’s LCD display unit and
parameters start to be installed.
Step 5 :
When parameters have been completely installed, “C
→
P Completed” appears in the printer’s
LCD display unit to indicate that the comparison of installed parameters has ended normally.
Step 6 :
Switch off and remove the flash memory card.
4.2.67.3 Verify
Step 1 :
Switch on power to the printer and verify that it is working normally.