MUTOH Rockhopper 38, Maintenance Manual

Page: 84 / 258

Rockhopper 38 – Maintenance Manual
84
AP-74038, Rev. 1.1, 25/01/05
4.7.2 Replacing the Ink ID assembly (Black, Yellow, Magenta, Cyan)
Step 1 :
Remove cartridge.
Step 2 :
Remove Front Cover. Refer to “Removing Front Cover”
Step 3 :
Remove Unit Panel Cover. Refer to “Removing Unit Panel Cover”
Step 4 :
Remove Y Rail Cover. Refer to “Removing Y Rail Cover”
Step 5 :
Remove Paper Guide R. Refer to “Removing Paper Guide R”
Step 6 :
Disconnect Junction Board Connector J406 (Ink ID BK), J407 (Ink ID C), J408 (Ink ID M), J409
(Ink ID Y).
Step 7 :
Remove Flexible Cable Attachment C (two fastening screws).
Step 8 :
Remove Y Rail Cover Support . Refer to “Replacing Cartridge Frame Assembly”
Step 9 :
Remove the Cartridge Mounting Plate from X Reinforcement R. Refer to “Removing
Step 10 :
Slide the Cartridge Unit a little way forward and lift it up. Refer to “Replacing Cartridge Frame
Assembly”
Step 11 :
Remove Ink ID Sensor 1 Assembly (BK) (one fastening screw).
Ink ID Sensor Assemblies 2 to 4 are handled as follows:
Step 12 :
Remove the Cartridge Mounting Plate.
Step 13 :
Cut the cable tie holding the Ink ID Sensor Cables.
Step 14 :
Undo the screw joints on each cartridge pipe in the Cartridge Frame Assembly.
Step 15 :
Remove the Cartridge Unit by pulling it forward.
Step 16 :
Remove the Cartridge Frame Assembly.
Step 17 :
Remove Ink ID Sensor Assemblies 1(C) to 4 (Y) (one fastening screw).
Step 18 :
To install removed components, reverse removal procedure.