multicomp pro MP720021, Manual

Page: 59 / 154

User Manual
54
In CAN bus trigger mode, the trigger setting information is displayed on bottom
right of the screen, for example,
，
indicates that trigger
type is CAN, CH1 trigger level is -126 mV.
CAN Trigger menu
list:
MENU SETTING INSTRUCTION
Bus Type CAN Set vertical channel bus type as CAN trigger.
Input
Source
CH1
CH2
CH3
CH4 Select CH1 as the trigger source.
Select CH2 as the trigger source.
Select CH3 as the trigger source.
Select CH4 as the trigger source.
Type
CAN_H
CAN_L
TX
RX Actual CAN_H bus signal.
Actual CAN_L bus signal.
Transmission signal on the CAN signal line.
Received signal on the CAN signal line.
Sample
Point
Turn the M rotary control (or tap on in touchscreen)
to set the Sample point, which is a point within a bit’s
time. The oscilloscope samples the bit level at this point.
“Sample point” is represented by the percentage of “the
time from the start of the bit’s time to the sample point
time” in the “bit’s time”. The range is 5% to 95%.
Common
Baud
Turn the M rotary control to select from the Baud list on
the left.
Custom
Baud
Turn the M rotary control (or tap on in touchscreen)
to set the Baud. The range is 10,000 to 1,000,000.
Tip : You can select the nearest value in Common Baud,
and then adjust it in this menu.
Condition
Start Trigger on the start frame of the data frame.
Type
Type
(Bottom
menu)
Data
Trigger on the selected frame.
Remote
Error
Overload
ID
Configure
(Bottom
menu)
Format Select Standard or Extended.
ID
Use the M rotary control and
Direction key on the front panel
to set.