7.4 Telephone OVERRIDE Command.
If
The
Power Stone is plugged into a power strip or wall outlet and you can't get to it to press the
OVERRIDE button, there is a touchtone command that will perform the same fúnction as pressing
the OVERRIDE button. To do this you must have a touchtone phone connected to the DEVICE
port. Press the * (star) symbol on your touchtone phone and The Power Stone will go into
OVERRIDE. To get The Power Stone out of OVERRIDE and back to its previous operating mode,
press the “Star” character twice, " * * “
.
“Telephone OVERRIDE Command” will only work when
the Power Stone is not in Manual Operating mode. Note:
If
you
are in the programming mode, you
cannot override by dialing “ * ". In the event of a power outage, both “override’s”, the button and
Register 05, revert to factory preset which is
“Normal Operation” or OVERRIDE off.
7.5 Status/Power LED.
The
Status/Power LED signals the status of
power supplied to your equipment. If the light
is blinking in a certain sequence, here’s what’s
going on:
1) OFF
-
There
is no power to The Power Stone.
The 120 Volt wall outlet is “dead” due to a
power outage on that particular circuit or
perhaps to your whole house.
2) OFF/Blinking On Briefly Once A Second -
The Power Stone is functional and has not been
activated. It is not supplying power to your
equipment.
STATUS
3)
ON/Winking Off Once A Second -
The
Power Stone has been activated and is supplying
power to your connected equipment.
4) ON/Solid -
The
Power Stone is in “Override” mode and is supplying power to your equipment.
5) ON/Blinking Rapidly
-
The
Power Stone is in Manual Operating mode and ready for
programming or readback.
7.6 Circuit “RESET” Button
At the bottom of The Power Stone is
a
15
Amp resettable breaker button.
This button resets The Power Stone
in the event that you overload its
circuit and trip the breaker. Please
pay special attention that you do not
plug in multiple devices that could
cause an overload to The Power
Stone. If The Power Stone circuit
breaker continues to blow, investigate
the load requirements of each device
that you have connected to The
Power Stone’s 120 Volt/15 Amp
receptacle.
