Executing Audible “Read Back” With The Power Stone:
First you must enter the Manual Operating mode by dialing “# # 8 8” (or your customized
code). Then press “*” and the register number you wish to read back.
An Exarnple:
-First, you press “# # 8 8” on your touchtone phone to enter the Manual Operating mode.
-The Power Stone responds with a “PROCEED” tone.
-You press “*01” (telling The Power Stone to audibly read back the value in Register 1).
-The Power Stone transmits 2 “Bips” signifying the value “2” (“Power On Call”).
-After a short pause, The Power Stone will transmit an “OK” tone followed by a
PROCEED” tone.
-At that time, you may either “read back” or program any register.
For Registers Containing More Than A Single Value
Register 6 can contain and does readback more than a single value. Here’s a short example of
what a “readback” would sound like where more than 2 digits or symbols are programmed in
the register.
-You first enter Manual Operating mode (# # 8 8 or your customized code).
-Press " * 0 6 " to “read back” Register 6.
-The Power Stone transmits “ Beep Beep (pause) Beep Beep “
(Because the register is not programmed with a custom Security Access Code, it contains the
numerical value, zero-zero. This translates into two sets of two low-pitched beeps.)
-The Power Stone immediately transmits the “OK” and “Proceed” tones.
Helpful Tips If You’re Having Trouble!
After entering # # 8 8 to get into Manual Operating mode, you have 30 seconds to enter a
complete readback command. After 30 seconds (if no readback information is entered) The
Power Stone will transmit an “Okay” tone (Bee-Bip) and exit programming mode. The Power
Stone acts as if you have dialed "90”.
Note: You wiII receive an “Error” tone when entering “*
”
(star)
register number on audible “read back". Never fear - try again!
and an incorrect or partial
