5) lf You Want To Call In From A Remote location And “Readback”
Programming And Power Status..... Installation -
Either Installation
1
or 2 is
suitable for this application (
Refer to Install. Overview
, page 20, 21).
To Enter Manual Operating Mode And Readback Programming And
Power Status To Your Equipment:
1) The Power Stone or answering machine answers your inbound call.
2) You enter # # 8 8 on the touchtone phone - The Power Stone “bips” 3 times (Proceed).
3) At that time, you enter “*” with the appropriate register number.
4)
There is a short pause followed by the register readback in the form of bips and/or beeps.
5) There is a short pause after the readback, then The Power Stone “bee-bips’* once (Info
Accepted) followed by 3 “bips” (Proceed).
6)
You
may readback another register at this time, or
7)
You press “80” on your touchtone key pad (saves programming). The Power Stone “bee-
bips” twice (exit). You hang up.
HelpfuI Típ: You can also change
Manual Operating mode. Dialing
Operating mode.
programming at any time before dialing "80" to exit
“80” saves programming to memory and exits Manual
4.1 “Rings To Trip” Feature
The Power Stone will perform any of three selected power operations (Automatic Operating
Modes) automatically when detecting ring voltage (as a number of rings) over the phone line
from an inbound call. The ring settings to”trip” your selected Automatic Operating Mode are
available in two options:
1)
2 Or Less Rings
- If The Power Stone detects two rings or less from an inbound call, it will
automatically perform the operating mode you have programmed. In this option, if The
Power Stone detects 3 or more rings, it will not be “tripped”; therefore no automatic
operation will occur.
2)
3 Rings or More
- Upon detecting a minimum of 3 rings on an inbound call, The Power
Stone will perform its automatic operating mode. If it detects less than 3 rings (2 or less
rings, option l), it will not be “tripped” and no automatic operation will occur.
Good Stuff To Know...
Remember that the “Rings To Trip” feature option (“2 or less” / “3
or more” rings) will only “trip” an automatic operating mode. In other words, it will only
work when programmed in conjunction with one of the three selectable automatic operating
modes (see
page 9
for an in-depth explanation). “Passive” Operating Modes (Passive On and
Passive Off ignore, or are passive to, all inbound cal1 rings and control power without
interference from inbound calls. See page
10
for info about “
Passive” Operating Modes.
