How you install The Power Stone is totally dependent on the type of equipment you wish to
control power to and if this equipment needs access to the phone line. Below are two general
installation applications that should give you a good idea of how to get optimal performance
when using The Power Stone.
1)
Controlling Power To Data Equipment That Requires Access To The Phone Line -
a)
The Power Stone is plugged into a 120 Volt wall outlet.
b)
The Power Stone is connected to the telephone line via the supplied line cord. One end is
plugged into the telephone wall jack and the other end is plugged into the port labeled
“LINE” .
120 VAC
WALL
OUTLET
PC, MODEM, FAX/ MODEM CARD,
LAN SYSTEM
c)
The data equipment you wish to control power to is connected to the 120 Volt receptacle
on the face of The Power Stone.
d)
The data equipment (PC, modem/fax card, fax machine, etc.) is connected to the phone
line (through The Power Stone) by plugging the RJ-ll line cord from your equipment
into the port labeled “DEVICE”.
Helpful Tips:
-
This is the required installation when using the “Power On Call” Automatic Operating
mode. Al1 auto-answer equipment (fax or modem devices) is required to be connected
through The Power Stone to the phone line for “Power On Call” to work properly.
- Other operating modes will function in this installation, such as “Reboot”
,
“Passive On” or
“Passive Off" and you can also access Manual Operating mode from a remote location.
20
