custom.
The Power Stone “Audible Readback” Response
: Answers with an “OK” tone, then a
“PROCEED” tone. You have
30
seconds to begin the next command.
3) You change the “Rings To Trip” feature to “2 or less” (factory preset “3 or more”) by
dialing
022. "02"
selects Register 2 and “2” means “2 or less rings”.
The Power Stone “Audible Readback” Response:
Answers with an “OK” tone, then a
“PROCEED” tone. You have
30
seconds to begin the next command.
4) You change the “Operating Mode” from “Power On Call” (the factory preset) to “Reboot”
by dialing
013. "01"
selects Register 1 and “3” selects “Reboot” mode.
The Power Stone “Audible Readback” Response:
Answers with an “OK
” tone, then a
“PROCEED” tone. You have 30 seconds to begin the next command.
5) You have finished programming the desired feature changes and wish to save them to
memory and exit Manual Operating mode. You dial “80”.
The Power Stone “Audible Readback” Response:
Answers with the “OK” to
ne twice. The
LED returns to normal blinking. Check and see if your mom is on the other end of the line. If
so, talk to her. You don’t call her enough. If not, hang up the phone.
NOTE: If The Power Stone does not receive a command within 30 seconds, it will give you
an “OK” tone and exit programming mode without saving any changes. Basically, it is acting
as if you have dialed “90” (See page
17,
the section titled
Programming Commands
).
The Power Stone requires 10 seconds after either party goes on-hook (hangs up) to reset itself.
Why is this important?
If you hang up on The Power Stone and immediately cal1 back within
10
seconds, chances are you will get a busy signal.
9.3 AUDIBLE “READBACK” OF
1
PROGRAMMING-
NUMBEFUSYMBOL AUDIBLE TONES
BEEP BEEP BEEP-BOOOOOOP!
1 “BIP”
There is a manual control command that
2 “BIP BIP”
allows The Power Stone to audibly
3 “BIP BIP BIP”
“readback” (via the phone) the value
4 “BIP BIP BIP BIP”
of any register. This feature is handy when
5 “BEEP”
you’re calling long distance to your home
6
“BEEP BIP”
and you have forgotten what you have just
7 “BEEP BIP BIP”
programmed and want a quick readback
8
“BEEP BIP BIP BIP”
when checking to see if The Power Stone
9 “BEEP BIP BIP BIP BIP”
is
properly programmed before leaving
0 “BEEP BEEP”
your home or office. There are two types of
*
“BEEP BEEP BIP”
tones that The Power Stone will transmit
#
“BEEP BEEP BIP BIP”
through your receiver on the audible
“ read
back”-
- A clipped, high-pitched “bip” which has a numerical value of one.
- A long, low-pitched “beep” which has the numerical value of five.
The chart to the right describes the audible tones which coincide with each number or
symbol in a register.
18
