Operating Modes
-
All operating modes, passive and automatic are contained in
Register 0 1. See sections titled
“Automatic Operation”
and
“Passive Operation
” for feature
explanation.
“Rings
To Trip" Automatic Operation -
Register 02 controls this feature setting.
Refer to “Rings To Trip Feature” in section titled “Automatic Operation”.
“Distinctive Ring” Cadence Detection -
Register 03 controls the setting for this
programmable feature. For full feature explanation, refer to
“Distinctive Ring Cadence
Detection”
in section titled “Automatic Operation”.
7.1 The Power Stone contains two "read only” programming registers.
-
The “Power Supplied” Status Register, Register 07, will readback the current status
of power supplied to connected equipment. Two low beeps tell you The Power Stone is
not supplying power to your equipment. One beep tells you power is supplied to the
equipment.
- The
“
Power
Failure”
Status Register, Register 08, will tell you if a power failure has
occurred since the last reading of this register. Two low beeps tell you power has not been
interrupted to The Power Stone since your last inquiry. One beep indicates that a power
outage has occurred since your last inquiry.
7.2
Audible
Readback Of All Programming.
Upon accessing The Power Stone’s Manual Operating mode, you can direct The Power Stone
to readback any programming and feature settings. (See
page 15
for a more in-depth
explanation).
7.3 Manual OVERRIDE Button
Pressing this button will direct The Power
Stone to supply a constant, uninterrupted
supply of electricity to your connected
equipment. The Power/Status LED will
glow brightly, with no flashing. All
inbound calls will be ignored by The Power
Stone. Pressing the “OVERRIDE” button
again will return The Power Stone to its
previous programmed operating mode. In
the event of a power outage, both
“override’s”, the button and Register 05,
revert to factory preset which is "Normal
Operation” or OVERRIDE off.
12
