9 MANUAL OPERATION/PROGRAMMING OF THE POWER STONE
This is the greatest asset of The Power Stone! You can call in to your home or Office from a
remoce location and control the power to your selected equipment or change the automatic
operation at the site of The Power Stone - just by pressing characters on your telephone key
pad! You can also check the status of each programmable setting and receive information
about power status to a device.
“Before You Can Access The Power Stone”-
If
you wish to access The Power
Stone’s Manual Control mode, from a remote location OR right on site, some basic
requirements need to be satisfied.
For “On Site” Access-
A TOUCHTONE telephone must be
connected to the “DEVICE” port of The
Power Stone. You may, if you have a
modem plugged into the “DEVICE”
port, connect your telephone to the
“Phone” port on the back of the modem.
If your modem does not have a “Phone”
port on the back panel and you need to
have a phone and modem
connected to the Power
Stone’s “DEVICE” port,
use a telephone
splitter/adapter. We
recommend a
splitter/adapter similar or
equal to the AT&T
adapter, part no. 267A2,
because of the
“over/under” splitter
configuration. This type
of splitter/adapter, when
plugged into The Power
Stone’s “DEVICE” port,
will not interfere with the
“LINE” port directly
beside it.
Access When Calling From A Remote location-
If you are calling from a remote
location, you must be placing the call from a touchtone phone and the call you place to the
location of The Power Stone must be “answered” by either:
A) an auto-answer device (like an answering machine, modem, fax machine), or
