MTD GCS 50/45, Operating Manual

Page: 46 / 392

46
6) Fully press down the air knob (choke) (fig.29),
so that the “THROTTLE ADVANCE” remains
engaged.
7) Continue to pull the starter cord (fig.28) until
the engine starts.
CAUTION-HAZARD! The cutting chain
moves because the throttle trigger is
partially advanced.
- Hold the chainsaw firm (fig.28) letting the en-
gine and chain run for at least 15 seconds (for
pre-heating).
8) Using the palm of your hand, press the throttle
trigger lock-out (fig.29part. 1) and then press
the throttle trigger (fig.29 part 2); this way
“THE
THROTTLE ADVANCEMENT” will disengage
and the engine will run at minimum speed.
9) Do not use the chainsaw if the chain
moves at the minimum engine setting.
Instead, apply to a service centre for assist-
ance.
10) Do not move or transport the chain-
saw with the engine running.
During transport, cover the bar with the protector
provided.
STOPPING THE ENGINE
1) To stop the engine, lower the switch lever to
the “ STOP “ position (fig.26 part. 1)
2) After working for a long period at full power,
it is best to leave the engine to run at minimum
speed for a few seconds before operating the
“STOP “ switch.
ATTENTION! Accustom yourself to oper-
ating the STOP switch so that you will be able to
act promptly in the event of an emergency.
ATTENTION! The chain continues to
move for a certain time after the throttle trigger
has been released.
7.2 STARTING WITH THE ENGINE HOT
1)
Raise the switch lever (fig.26 part.1).
2) Pull the air knob as far as it will go and then push
it in to engage “THROTTLE ADVANCEMENT”.
3) Give the starter cord handle a strong pull until
the engine starts (fig. 28).
STARTING WITH THE ENGINE HOT AFTER
REFUELLING
1)
If the fuel tank has been emptied completely,
after refuelling follow the instructions given for
“STARTING WITH THE ENGINE COLD “.
ENGINE STOPPED. The engine must ALWAYS
be off while the following operations are being
performed.
#
Refuelling
# Topping up the chain oil
# Making checks and repairs
# Cleaning and making adjustments
# Moving from one place to another at the work
site
# Transport
ENGLISH
Fig.29
1
2
CHAIN SAW OPERATING MANUAL
GB