5 - 18 Omnii (Windows Embedded Hand-Held 6.5) User Guide
Troubleshooting
Omnii Charge Indicator LED Stays Off
When Omnii is docked in a powered ST4004 and the hand-held’s charge indicator LED stays off, there may be
a problem with Omnii or with the docking station. Make sure a battery is installed in the Omnii, otherwise use
an Omnii with a properly functioning charge indicator to isolate the problem.
Power LED Does Not Light Up
•
Remove all Omnii units, and unplug the docking station.
•
Connect another device to the mains outlet to ensure there is power.
•
Remove the IEC mains power cable from the charger, and check it for damage.
•
Reconnect the mains cable in the charger and mains outlet.
Omnii Charge LED Flashes Yellow
A flashing yellow Omnii charge LED (the left-most LED on the hand-held) indicates that the battery is not within
the allowable charging temperature range – 0° C and 40° C (32° F to 104° F). Allow the battery to come to an
acceptable range before reinserting Omnii in the docking station.
Omnii Charge Indicator LED is Red
If the Omnii charge indicator is red when Omnii is in any of the four bays, the quad dock cannot read the
battery, is in charging timeout, or it is not a Motorola battery.
•
Remove the computers and disconnect the adaptor DC power cable.
•
Wait at least 20 seconds, and then plug the cable in again.
•
If the Omnii indicator still shows a fault, Omnii requires service.
Powered Adaptor LED Stays Off
•
Check the AC cable. Replace with the same type if the cable is suspect.
•
If the adaptor LED stays OFF, the adaptor is defective and requires service.
Vehicle Cradles - Models ST1000 and ST1002
The Omnii vehicle cradles are highly ruggedized, single station docks. Although they provide quick insertion
and removal, the cradles hold Omnii securely even when operated in high vibration environments (such as
vehicles not equipped with suspensions).
The Omnii vehicle cradle is available in two models:
•
Model ST1000 - Unpowered cradle.
•
Model ST1002 - Powered cradle with communications port. A DE9M serial port (powered) and two USB
Host interfaces.
IMPORTANT
The vehicle cradles are shipped with their own quick start guide —
Omnii Vehicle Cradles Quick Start Guide (PN 8000221). It is critical
that it be reviewed for additional information and updates.
Summary of Contents for Omnii
