- 50 -
5.0
5.0
SEATING ACCESSORIES & COMFORT ADJUSTMENTS
SEATING ACCESSORIES & COMFORT ADJUSTMENTS
FLIP-BACK ARMREST
Each Recline Cantilever Armrest (left and/or right) can be independently rotated (“flipped”) backward to assist
with side transfers. To place the armrest in the fully flipped back position, simply lift upward on the armrest (
1
)
until it is rotated past the recline back canes as illustrated below (
2
).
FULL FLIP-BACK
POSITION
(left armrest shown)
WARNING! Risk of serious injury or damage
•
Do Not drive or operate the Rovi-MPS System with the armrests in the raised/flipped back position
1
2
Angle Adjust
Set-Screw
4
mm
hex key
ARMREST ANGLE ADJUSTMENT
Adjust Clockwise:
to Raise Arm Angle
Adjust Counter-clockwise:
to Lower Arm Angle
Adjusting the Angel of the Recline Cantilever Armrest:
(repeat for each armrest)
1. Using a 4mm hex key tool, rotate the set screw in the armrest mounting bracket CLOCKWISE to RAISE/
INCREASE the armrest angle, or COUNTER-CLOCKWISE to LOWER/DECREASE the armrest angle (
1
).
1
The angle of the Recline Cantilever Armrests (left and right) may be adjusted independently to achieve the
desired arm angle/position.
Note:
The armrest angle is set relative to the recline back canes, therefore the
armrest position (angle) will remain consistent with the back angle of the seating system when it transitions
through the various power positioning functions (i.e. Tilt, Recline, Stand).
5.2.2 ARMREST ANGLE ADJUSTMENTS
5.2.3 ARMREST “FLIP-BACK” FEATURE