60
Motion Computing LE-Series and LS-Series Tablet PCs User Guide
• Even with the Narrow Angle setting, if a sound is loud enough and within the
angle of acceptance (no matter how distant), the sound will be picked up by the
microphones. The advantage of the Tablet PC is that it detects fewer
extraneous sounds than other audio systems. You can further limit the
detection of these outside sounds by turning down the microphone volume and
speaking louder; this reduces the microphones’ range and restricts the
capability to detect extraneous sounds.
• The Tablet PC contains pre-installed audio components. If you install a third-
party audio device (such as USB or Bluetooth devices), the Motion-installed
audio may not work. If this happens, you must
reinstall
the Motion-audio
components. (The Motion audio components are the SigmaTel and Knowles
Acoustics audio drivers.) After you install these, if you still have problems
recording, contact Motion Technical Support or the Bluetooth or USB
manufacturer’s technical support.
• To improve speech recognition, run additional speech training sessions. Open
the Windows Control Panel and select Speech to perform additional speech
training. As you do this, speech recognition accuracy will gradually improve.
P
ORTS
AND
S
LOTS
PC Cards (LE-Series)
The PC Card Slot, also referred to as a PCMCIA Card Slot, holds one Type-II PC
Card for networking, memory expansion, or accessory connection.
1. To install a PC Card, insert it label side up.
2. To remove a PC Card, push the button next to the slot until it pops out.
3. Push it again to eject the PC Card.
NOTE:
Your Tablet PC ships with a plastic blank card in the PC Card
slot. When the slot is not in use, we recommend that you leave the
plastic blank in place.
Secure Digital (SD) Cards
The SD Card Slot holds one SD Card for networking, memory expansion, or
accessory connection.
1. To install an SD Card, insert it in the slot, label side up.
2. To remove the SD Card, grip the edge of the card and carefully pull it from
the slot. Notice that the edge of the Tablet PC is curved slightly in the area
of the SD Card. This makes it easier to grip the edge of the card for inser-
tion and removal.
Infrared (IrDA) Port
The IrDA port uses the infrared connection protocol to transfer data or digital
images from any IrDA enabled device to a specified file location on another IrDA
equipped device. Typically, the devices must be within three feet of each other.
Refer to the “Using Infrared Wireless Connections” on page 70 for more
information.
USB Ports
There are two high speed USB ports on the Tablet PC that can be used to attach
any USB device to the Tablet PC. Typically a USB device draws power from the
Tablet PC, therefore it is advisable to use AC power whenever USB devices are
attached. Running USB devices while operating on battery power will adversely
affect your rate of power consumption.
