Moeller XControl XC600, Hardware, Engineering And Function Description, Page: 54 / 78

Menu overview of the operator
module
07/04 AWB2700-1428GB
50
HARDWARE
CONFIG: after the CONFIG menu has been called, the present
hardware configuration (not drivers) of the XC600 is presented.
AUTOCONFIG: when the device is delivered, the AUTOCONFIG
function is switched on. In this state, the system will scan the
module configuration on startup. If the configuration does not
change, for example, after commissioning has been completed,
the configuration can be “frozen” for diagnostic tasks.
To do this, disable the AUTOCONFIG function:
X
Choose MAIN MENU r DEVICE r HARDWARE r
AUTOCONFIG.
The cursor will be positioned to ON:
X
Turn the MSS until the display shows OFF.
X
Press the MSS. The word ENTER will appear on the display.
X
Press the MSS to return to the menu.
This function can be reactivated at any time.
If the AUTOCONFIG function is switched off, then the PLC will
detect a missing or faulty module at the next startup. This is
indicated by the SF LED lighting up.
The following error text will appear in the DIAGNOSTICS r ERROR
menu:
The number 1 in the designation XC-NET-1 indicates the module
(address):
MAIN MENU: SYSTEM
In this menu you can shut down the operating system or initiate a
new start (reboot).
Turn the MSS to select either SHUTDOWN or REBOOT.
HARDWARE:
CONFIGURE
AUTOCONFIG
BACK
XC-CPU601-4
XC-POW50-XU
XC-NET-DP-M
XC-SYS1
BACK
AUTOCONFIG:
ON
BACK
Number (Hardware) address of the module
0 CE000
1 CC000
2 D4000
05.12_15:32
XC-NET-1
NOT DETECTED
BACK