Mobotix AllroundDual M16B, Manual

Page: 47 / 124

47
First Installation Steps
6. Lock the sensor module: Using the black module
wrench, turn the sensor module clockwise until it
stops.
Repeat steps 3 to 6 for the second sensor module or the blind module, respectively.
Installing
the blind module is a mandatory prerequisite when using the M16 as a mono camera
with only one sensor module.
Caution
Note that the sensor modules are not yet protected against theft and unwanted rota-
tion (e.g., due to vibration). In such a case, it is
highly recommended to install the
security clips (M.11):
• Section 2.2.2, «Opening the Camera Housing»
• Section 2.2.3, «Installing the Security Clips (Optional, Not
Required for M16 Complete Cameras)»
• Section 2.2.8, «Closing the Camera Housing»
2.2.2 Opening the Camera Housing
The following tasks require opening the camera housing and removing the front element
of the M16 in order to get to the interior of the M16:
• Inserting security clips at the sensor module or the
blind module, respectively.
• Exchanging the MOBOTIX Ethernet patch cable against
a longer MOBOTIX patch cable.
• Connecting an MxBus
*
two-wire cable in order to
attach MxBus extension modules (e.g., the «MX-GPS-
Box»).
• Connecting a MOBOTIX USB cable in order to attach
external data storage devices or an «MX-232-IO-Box».
• Exchanging the pre-installed MicroSD card against
a larger one or as preventive maintenance measure
(see Section 3.5, «MicroSD Card Recording»).
Blind module
*Only supported by
Mx-M16B variant