© MOBATIME
64 / 84
800847.08
9.2
Device configuration with SNMP
If one or several variables are set with
Put
in a configuration group, the variable
dts4128????ConfigCmd
must be set at the end to 1 in the corresponding group. The
values of the entire configuration group are assumed from the DTS with this command
(1=accept).
As long as the accept command has not been set, the changed variables can be restored
to the old values by setting the
dts4128????ConfigCmd
variable to 2 (2=undo, restore).
After sending the accept command, a dts4128ConfigChanged
Notification
is sent.
The definitions of the available variables can be taken from the MIB files.
Example:
Management-System
DTS
Put
dts4128FTPMode=1
Variable is set to 1 internally
Put
dts4128NetServicesConfigCmd=1
Configuration group is assumed
Sends dts4128ConfigChanged
Notification
with the new time
dts4128NetConfigChangedTime
9.3
DTS subagent SNMP notification
Protocol: SNMPv2c Notification
For
Notifications
to be sent out, SNMP must be switched on. In addition, at least one
receiver system must be configured.
9.3.1
Start up
[dts4128StartUp]
Sent out when the subagent for the DTS is started.
This
Notification
is always sent out, as soon as SNMP is activated and a destination
address is configured.
9.3.2
Shutdown
[dts4128Shutdown]
Sent out when the subagent for the DTS is stopped.
This
Notification
is always sent out, as soon as SNMP is activated and a destination
address is configured.