Operating instructions CLIMACELL Page 10
V 1.07_Blue Line CLIMACELL_PCH_en_np_mmm
!
0208
Parameter change:
Move the cursor horizontally by pressing
◄►
. Change the parameter above the cursor by
pressing
▲
.
4.4
General setup of CLIMACELL
CLIMACELL – MMM’ s product – offers a wide range of customer’s benefits. In order to
make them active, there are fundamental inputs required. To achieve this the following
service mode containing 7 different services is here.
4.4.1 Activating the service mode
Press simultaneously buttons
▲►
for 2 seconds. LCD shows Service 01. By pressing the
button
▲
you can change between the single service modes Service 01 – Service 08.
4.4.2 Service 01 – Storing P1 – P4, or P5, or P6 to chip card
With help of this service you can store programs
P1 – P4, or P5, or P6 on the MMM s chip
card. Before storing the parameters to the chip card it necessary to insert the right card to the
unit panel. These cards can be ordered optionally.
Make sure that the chip card is in the card reader!
Press START/STOP to do storing. The transmission is confirmed by the read out „Done“ on
LCD. Press START/STOP again to enter another service. If the read out on the LCD is „Bad
MMM CCard“, check the chip card and repeat the procedure.
Pressing START/STOP enter the program storing service at first.
The choices P1 – P4,or P5 or P6 are available. Select by pressing
▲
.
To store the program press button
.
(In detail:
Before the start:
the display indicates: „Service 01“
„Save to CCard“
After the start: on the second line of the display by pressing
▲
select what will be saved on
the chip card. Choices
- all eligible parameters of P1 to P4 at once - the display indicates:
„P1
÷
4
→
MMM CCard“,
- all eligible parameters of P5 - the display indicates:
„P5
→
MMM CCard“,
- all eligible parameters of P6 - the display indicates: „P6
→
MMM CCard“.
The storing of your choice on the chip card is done by pressing
If an incorrect card is
placed into the unit, the display indicates: “Bad MMM CCard“. If everything is all right, the
indication is: “Done“.)
Quit the service by pressing START/STOP again.
4.4.3 Service 02 – Restore/upload the programs from the chip card to the unit
With help of this service you can record the programs P1 – P4, or P5, or P6 stored on the
chip card again to the unit’s memory (see
3.1.2
). The programs in the memory will be
recorded over (erased). Make sure the chip card is in the card reader. Press START/STOP
to record. The transmission is confirmed by the read out „Done“ on LCD. Press
START/STOP again to enter another service. If the read out on the LCD is „Bad MMM
CCard“, check the chip card and repeat the procedure.
