Chapter Two: Installation
Setup
11
Mounting
The 1152 unit has four mounting holes in its base plate as shown in Figure 6. The centers of
these slots form a rectangle 8.75 inches long by 2.62 inches wide.
Mounting Holes
Mounting Holes
Figure 6: Location of the Mounting Holes
Follow these guidelines when mounting the 1152 unit:
Warning
Read and follow all messages in
Safety Procedures and
Precautions, page1, BEFORE attempting to install the 1152
unit. Failure to adhere to these messages could result in
injury to personnel.
1. Close all valves between the 1152 MFC and the vapor source before installing the unit.
2. Connect the input fitting on the 1152 unit to the vapor source.
3. Connect the outlet fitting to the downstream side.
4. Allow clearance to provide access to the connectors and the ZERO and GAIN pots.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
