MK-370
Revision 06/05, Effective Date June 17, 2005
Page 19
SETUP, ADJUSTMENT and OPERATION
2. Diagonal Cutting:
NOTE: To cut diagonal, the Dual 45º Flat Angle Guide (MK Diamond Part No. 134557-MK) should be used.
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was designed.
NOTE:
If Cutting the tile in two equal halves, align the tile in the V-notch of the Movable Cutting Table
Ruler/Stop.
(A)
Remove the Adjustable Cutting
Guide
(F)
Turn the motor ON
(I)
Turn the motor OFF when work
is complete
(B)
Place the Dual 45º Flat Angle
Guide on the Ruler/Stop
(D)
Position the Dual 45º Flat
Angle Guide and tighten the
retaining thumbscrew
(E)
Position the tile against the
Dual 45º Flat Angle Guide and
the Ruler/Stop
(H)
Perform the cut
Off
Position
ON/OFF
Switch
Cooling Flow
Points
(G)
Verify proper cooling flow on
both sides of the blade (See
Maintenance Section to
increase/decrease flow)
(C)
Align the Dual 45º Flat Angle
Guide for the desired
Cut Length
Ruler/Stop
Ruler/Stop
Turn - clockwise to
loosen
Align Guide
for Cutting
Turn counter-
clockwise to loosen
Adjustable
Cutting Guide
On
Position
ON/OFF
Switch
Turn clockwise
to tighten
45º Flat
Angle Guide
Ruler/Stop
Hold Work
in position
Direction
of Cut
