MK-370
Revision 06/05, Effective Date June 17, 2005
Page 17
SETUP, ADJUSTMENT and OPERATION
3. MK-370 Setup for Operation:
1. Before connecting the MK-370 to a power supply, be sure the voltage, cycle and phase meet the
requirements of TABLE 3 below.
VOLTAGE – 115V
CYCLE – 60 Hz
PHASE – 1 Phase
TABLE 3
2. If using an extension cord, make sure the length and wire gauge correspond to the requirements
listed in TABLE 1 on page 8. An extension cord that is too small in wire gauge (diameter), or too
long in length, will cause the motor to overheat and could cause premature failure.
3. Use an approved Ground Fault Circuit Interrupter (GFCI)
4. Do not cover the motor vents as this could lead to motor overheating.
NOTE: In order to avoid breaker tripping, a 20-amp circuit breaker should be used.
(A)
Plug MK-370 into the GFCI (A
GFCI should always be used
when operating the MK-370)
(C)
Plug the GFCI into the Power
source
GFCI
GFCI Plugged
Into Power
Source
(F)
Connect the Water Pump power
cord to the connection found on
the back of the motor
(E)
Fill the Water Pan with clean
water covering the Pump
Suction (this should be done
periodically during cutting)
(D)
Place the Water Pump in the
Water Pan with the Suction
down and insert the Pump
Cord to the Clip in the back
Cord Clip
Water
Pump
Fill with
clean water
Cover Pump
Suction
Pump
Cord
Pump
Connection