TAPCO TOOLS S2X, Installation Instructions

Page: 1 / 4

1
Remove all parts from box
STEP 1: ATTACH WIDTH ADJUSTER
Attach the Width Adjuster to the back rail in between the
castings, approximately 4' apart (
Fig. 1
). Tighten the thumb screw.
STEP 2: PIVOT BAR ASSEMBLY
Note: Pivot Assembly is shipped set up for a Pro 14
®
install. For
Pro 19
®
, rotate pivot arm 180 degrees (
Fig.2
)
Ensure the brake is in the closed position. Insert slot end of Pivot
Bar onto the anvil (
Fig.3
). Fasten bottom of Pivot Bar Assembly to
Width Adjuster and tighten firmly (
Fig. 4
). The fit should be snug
and square. The Pivot Bar may have slight side to side movement.
KIT INCLUDES:
1
(2) Pivot Bar Assembly
2
(2) Material Stop
3
(2) Width Adjuster Assembly
4
(2) 3" Measurement Stickers
5
(2) 20" Grey/White Measuring Tape
6
(2) Cut-Off Tape
TOOLS NEEDED:
ƒ Phillips Screwdriver
ƒ Utility Knife
ƒ Speed Square
ƒ Pencil
ƒ (3) 12x12 Pieces of Trim Coil
ƒ PRO Cut-Off (Optional)
Fig. 3 Fig. 4
INSTALLATION INSTRUCTIONS
1
1
2
2
3
4
5
6
Fig. 1
Fig. 2
PRO 14
®
Set-Up
PRO 19
®
Set-Up