2-12
Installation
2 Unpacking to Installation
2.2.6 Connecting with the controller
Fig.2-5: Connecting the machine cables
Carry out the following procedure after installing the controller referring to the separate "Controller Setup
and Maintenance" manual.
Fig.2-6: Connecting with the controller
1) Make sure that the power of the controller is turned OFF.
2) Connect the controller side connector of the machine cable to CN1 connector on the rear side of the
controller.
3) To fix the inserted connector, close the latches of the CN1 connector.
4) The connection method is the same for the optional machine cables (replaceable type).
When connecting and disconnecting the connector, be careful not to get your
hand pinched.
When installing or removing the connector, to the connector of the other party in
parallel, install or remove.
If load strong against one side is applied, the connector pin may be damaged
and it may not be connected securely.
To disconnect the cable, open the latches, hold the connector part, and pull out
the cable. Pulling the cable part may cause the cable to come off or break.
Latch
CN1 connector
Machine cable
controller side connector
CAUTION
CAUTION
CAUTION
