Mitsubishi Electric KD Series, User Manual

Page: 44 / 118

© Mitsubishi Electric Corporation
【
Remark
】
How to install CIS into your equipment
①
Attach CIS to your system at both end sides of CIS
by M4 screws.
Focal point is defined the position from the datum holes
at the end of CIS.
There is the focal point of CIS at 62.5mm from the datum holes.
②
There are 4screw holes(M4) each end side of CIS (total 8 screw
holes). Use datum holes (φ3 hole and 3x4slot ) to make sure the
CIS is on the right position.
③
Please fasten between CIS and your equipment
by M4 screws with 4 internal threads in front of CIS.
Use 2 datum holes (3x4slot or 3x5slot) to make sure the CIS is
on the right position.
Furthermore, when the CIS is installed to your equipment,
to absorb small deformation of CIS(for example, the bend of
aluminum parts of CIS),
please make the through holes to fix between CIS
and your equipment in the bracket prepared by customer as slot.
(Detail is shown in next page.)
④
To install CIS in your system, please use all
of fastening points (12points).
Recommended way to fasten torque is shown in below table.
Material of screw
Fastening torque [N
・
cm]
Iron (strength ranking 4.6)
165
±
16
Stainless (SUS 304)
144
±
14
Brass (C3601BD)
96
±
9
⑤
A frame of CIS is made of aluminum. When fasten a
screw, be careful about thread damage of screw hole.
⑥
Pin length for adjusting position of CIS is 5.0mm or less.
⑦
Maximum product length of this product is 1.7m. When
this product is carried or installed into your system, please
be careful surrounding you and this product. And please do
not hit anything.
3-1-7 Both Side of CIS
3-1-8 The view of fixing construction in front of CIS from side
44
Pin Length
5.0mm max.
Pin Length
5.0mm max.
Bracket prepared
by customer
Detail B(Cross section)
Bracket prepared by
customer
Bracket prepared by
customer
3-1 Installation
TM-XJ959A