Mitsubishi Electric FR-E700EX, Instruction Manual

Page: 124 / 323

122
Speed setting by external terminals
4.8.3 Remote setting function (Pr.59)
The above parameter can be set when Pr.160 Extended function display selection = "0". (Refer to page 182)

External running speed (other than multi-speed) or PU running speed
NOTE

The
Pr.15
setting should be equal to or higher than the
Pr.13 Starting speed
. If "0r/min" is set in
Pr.15
under position
control, no position command is created and the stop state remains.
 The JOG signal (JOG2 signal) can be assigned to the input terminal using any of Pr.178 to Pr.184 (input terminal function
selection) . When terminal assignment is changed, the other functions may be affected. Set parameters after confirming
the function of each terminal.
 During Jog operation, the second acceleration/deceleration via the RT signal cannot be selected. (The other second
functions are valid. (Refer to page 141) )
 When Pr.79 Operation mode selection = "4", pressing of the operation panel and / of the parameter unit
(FR-PU07) starts the drive unit and pressing stops the drive unit.
 This function is invalid when Pr.79 = "3".
Parameters referred to
 Pr.29 Acceleration/deceleration pattern selection Refer to page 129
 Pr.20 Acceleration/deceleration reference speed Refer to page 125
 Pr.79 Operation mode selection Refer to page 186
 Pr.178 to Pr.184 (input terminal function selection) Refer to page 138
 Even if the operation panel is located away from the enclosure, you can use contact signals to perform continuous
variable-speed operation, without using analog signals.
 By merely setting this parameter, you can use the acceleration, deceleration and setting clear functions of the
motorized speed setter (FR-FK).
Parameter
number
Name Initial value
Setting
range
Description
RH, RM, RL signal
function
Speed setting
storage function
59 Remote function selection
0
0 Multi-speed setting —
1 Remote setting With
2 Remote setting
Not used
(Turning the power OFF
clears remotely-set speed.)
3 Remote setting
Not used
(Turning the power OFF or
STF/STR OFF clears
remotely-set speed.)
Forward rotation
Acceleration
Deceleration
Clear
Drive unit
Connection diagram
for remote setting
STF
RH
RM
RL
SD
10
2
5
0
ON ON ON
ON
ON
ON ON ON ON
ON ON
Deceleration
(RM)
Clear (RL)
Acceleration
(RH)
(STF)
Power supply
0r/min
Time
Rotation speed (r/min)
∗
When Pr.59 =1
When Pr.59 =2, 3
When Pr.59 =1, 2
When Pr.59 =3
Forward rotation